Air flow monitor RHEASREG® KLSW 6 (auto. Reset)

Item no. 1701-3022-0001-000

Product group: WG01

Air flow monitor RHEASREG® KLGF / KLSW

Electronic RHEASGARD® KLGF duct air flow transmitter with active output, in an impact resistant plastic housing, optionally with/without display, for determining flow velocity in m/s. The measuring transducer converts the measured value into a standard signal of 0-10 V.

ElectronicRHEASREG® KLSW duct air flow monitor with switching output (one-step or two-step relay), in a plastic housing, for determining flow velocity in m/s. Fine adjustment of the measuring range end value by the user is possible with the help of a potentiometer.

The flow sensor devices are suitable for monitoring or controlling airflow in ducts, at ventilators and dampers, for flow-dependent monitoring of humidifiers and electric heating registers according to DIN 57100, part 420, or for use in connection with DDC systems.

Data points

flow velocity

Output

1 or 2 potential-free relays (changeover contacts)
8 A, max. 2 kW or 0 - 10 V (relative, linearised on request)

Current consumption

approx. 3 VA

Measuring range

0.33...49.2 ft s

Medium

pollutant-free, non-precipitating air

Process connection

by mounting flange
(included in the scope of delivery)

Max. sensor cable length

164 ft, avoid laying parallel with mains voltage-carrying lines,
or use shielded cables, minimum cross section AWG 16
per conductor, apply cable screen one-sided

Cable connection

cable gland, plastic (M 16 x 1.5; with strain relief, exchangeable, max. inner diameter 0.4 in) or
M12 connector according to DIN EN 61076-2-101 (optional on request)

Cable gland

M 16 x 1.5, including strain relief, exchangeable,
max. inner diameter 0.4 in

Protection type

IP 65 (according to EN 60 529)*

Protection type housing

IP 65

Standards

CE conformity,
EMC directive 2014/ 30/ EU,
low-voltage directive 2014/ 35/ EU

Operating instructions

Catalogue page EN

CE - Declaration of Conformity

Dokument