Für jede Anwendung die richtige Lösung [Translate]
Electronic frost protection thermostat ⁄ frost monitor THERMASREG® FS with continuous and switching output, fully-active copper sensor rod, with additional control input 0 - 10 V and summation output 0 - 10 V. The frost sensor is used to monitor air conditioning systems, heat exchangers, heating registers and similar equipment to prevent frost damage and freezing up. Falling below the limit value at the coldest measuring point of the capillary tube is detected.
In case of capillary breakage, power failure, or electrical damage to at the device, the relay in the frost monitor automatically switches to frost.
MK-05-K mounting clamps are included in the scope of delivery.
|Voltage supply||24 V AC ⁄ DC|
|Load resistance||RL > 5 kOhm|
|Switch-on ⁄ start-up time||< 1 min|
|Response time||t90 < 5 s|
1 x 0 -10 V (equivalent to 0...+15 °C)
1 x 0 -10 V summation output (frost signal and control voltage)
1 x potential-free changeover contact (24 V),
setting range 0...+15 °C
|Measuring range||0...+15 °C|
|Accuracy||typically ± 1 K (at +10 °C)|
|Ambient temperature (Enclosure)||–15...+50 °C|
by mounting clamps MK- 05 - K
(included in the scope of delivery)
|Electrical connection||0.14 - 1.5 mm² via terminal screws|
material polyamide, 30 % glass-globe reinforced,
with quick-locking screws
(slotted ⁄ Phillips head - combination),
colour traffic white (similar to RAL 9016)
|Enclosure dimensions||126 x 90 x 50 mm (Tyr 2)|
2x M 12 x 1.5 (Y-adapter); with strain relief,
exchangeable, max. inner diameter 6 mm
|Sensor and capillary||copper, active over the entire sensor length, min. 25 cm|
|Temperature (Sensor and capillary)||
(capillary tube at a distance > 20 cm away from enclosure)
|Hysteresis of switching step||2K|
|Permissible air humidity||< 95 % r. H., non-precipitating air|
|Protection class||III (according to EN 60 730)|
|Protection type||IP 65 (according to EN 60 529)|
electromagnetic compatibility according to EN 61326,
according to EMC Directive 2014 ⁄ 30 ⁄ EU
ISH Messe Frankfurt – S+S Regeltechnik looks forward to meeting you!
11. - 15.03.2019
Stand 10.3 A71
At the ISH, the world's leading trade fair for "The Bathroom Experience,...
Multi-functional duct sensor for monitoring and control of heating, ventilation and air-conditioning systems
This bus capable and calibratable pressure measuring transducer enables the control of differential...
Good room climate is measurable! - AERASGARD® FSCO2 ⁄ FSTM-CO2 ⁄ FSFTM-CO2-Modbus
Our multifunctional room sensors for measuring temperature, humidity and CO2 concentration can now...