HFTM-U LCD

THERMASGARD® HFTM-U DISPLAY

Item No. 1101-1151-2219-920
EAN 4 251325 600673

Calibratable temperature measuring transducer with sleeve sensor THERMASGARD® HFTM with  eight switchable measuring ranges, continuous output, with or without optional display, housing made of impact-resistant plastic with quick-locking screws. The temperature transmitter with remote sensor is used for temperature detection in liquid and gaseous media, e.g. by installation inside an immersion sleeve, or as duct sensor. Direct and permanent use in liquids is possible in combination with THE immersion sleeves (see last chapter). The sensor is factory-calibrated; an environmental precision adjustment by an expert is possible.

134,39 € net
Voltage supply 24 V AC/ DC (± 10 %)
Power consumption < 1,0 VA/ 24 V DC
< 2,2 VA/ 24 V AC
Load resistance RL > 5 kOhm
Deviation of humidity typically ± 0.2 K at +25 °C
Output 0 - 10 V
Sensor Pt1000, DIN EN 60751, class B
Connection type 2- or 3-wire connection
Measuring ranges multi-range switching with 8 switchable measuring ranges,
see table (other ranges optional)
with manual zero point correction (± 10 K)
Ambient temperature Measuring transducer –30...+70 °C
Protective tube (sensor sleeve) stainless steel, 1.4571, V4A, Ø = 6 mm,
nominal length (NL) = 50 mm
(other dimensions optional)
cable entry stamped (optional rolled)
Electrical connection 0.14 - 1.5 mm²
via terminal screws on circuit board
Cable connection cable gland, plastic (M 16 x 1.5; with strain relief, exchangeable, max. inner diameter 10.4 mm) or
M12 connector according to DIN EN 61076-2-101 (optional on request)
Housing plastic, UV-stabilised,
material polyamide, 30 % glass-globe reinforced,
with quick-locking screws
(slotted/ Phillips head - combination),
colour traffic white (similar to RAL 9016),
housing cover for display is transparent !
Housing dimensions 72 x 64 x 43.3 mm (Tyr 1 with Display)
Cable gland M 16 x 1.5, including strain relief, exchangeable,
max. inner diameter 10.4 mm
Connection cable silicone, SiHF, 2 x 0.25 mm², KL = 1.5 m (other lengths and
range limits optional, e.g. PTFE leads up to +250 °C
or glass fibre with steel wire mesh up to +350°C)
Permissible air humidity < 95 % r. H., non-precipitating air
Protection class III (according to EN 60 730)
Protection type IP 65 (according to EN 60 529) humidity-tight stamped
IP 68 (optional watertight compound-filled) rolled
IP 54 (optional glass fibre cable)
Standards CE conformity,
electromagnetic compatibility according to EN 61326,
according to EMC Directive 2014/ 30/ EU
Display display with illumination, two-line, cut-out approx. 36 x15 mm (B x H),
to display the actual temperature and internal diagnostics
(measuring range exceeded, measuring range not reached,
sensor breakage, sensor short circuit)
Type Item No. Price
0,00 €
WLP-1 Heat-conductive paste Silicone-free heat-conductive paste 7100-0060-1000-000 2,92 €